HYDRO JETTING

Hydro Jetting in Des Moines, IA

Water jetting that strips grease, soap and mineral crust, lint and root fibers from Des Moines drain and sewer lines, after a camera check shows the pipe can take it.

OVERVIEW

What Hydro Jetting Does for a Des Moines Drain

Hydro jetting is a drain cleaning method that drives a high pressure water stream through a hose and nozzle to scrub grease, scale, sludge and root fibers off the full circumference of a pipe. A cable machine bores a path through a blockage. A jetter removes the buildup that was narrowing the pipe. We at Clog Busters jet kitchen, laundry, floor drain and sewer lines across Des Moines from our branch at 3950 Vandalia Road, open 24 hours a day, 7 days a week.

Local water explains part of that buildup. According to Des Moines Water Works, the utility lime softens its river water and aims to keep total hardness below 150 mg/L, or 8.76 grains per gallon, and it notes that excessive hardness may adversely affect home plumbing. Minerals left in moderately hard water combine with soap and cooking fat into a crust on the drain wall that a cable slides right past.

A camera goes through the line before the jetter does. If it shows cracks, offset joints or cast iron worn thin, we stop and walk you through repair options instead. Jetting here is part of our hydro jetting service, begins with our drain camera inspections, and sits alongside our drain cleaning in Des Moines and our Des Moines drain and sewer services.

Any repair the camera calls for after jetting follows the Iowa State Plumbing Code, which has been the 2024 Uniform Plumbing Code since March 26, 2025.

Hydro jetting equipment inside a Clog Busters service van

JET OR NOT

When Jetting Is the Right Call in Des Moines, and When It Is Not

The camera decides. Sound pipe with a coating gets jetted. Broken or paper thin pipe gets a repair plan.

Grease Left Behind by Dishwashing

The Des Moines Metropolitan Wastewater Reclamation Authority says most fat, oil and grease reaches the sewer during cleanup, as dishes and cookware are washed. Inside the house, that residue lines the kitchen branch first.

Soap and Mineral Crust in Bath Lines

Tub and shower drains hold hair bound up in soap film and hard water deposits. Scouring the branch back to the stack leaves the next clump nothing to cling to.

A Laundry Standpipe That Spills

Washer discharge carries lint, fabric fibers and detergent residue that settle into a mat. When the standpipe overflows mid cycle, jetting clears the drain past the box.

Sand and Silt in a Floor Drain

Basement floor drains collect grit tracked in from outside or washed down from window wells. Water pressure lifts settled sediment that a cable leaves in place.

Not for a Cracked or Offset Line

When footage shows a break, a separated joint or a missing pipe bottom, jet water can wash soil into the pipe and enlarge the failure. That line needs repair first.

Not for Cast Iron Rusted Thin

Iron that has rusted through in spots, or shows a deep channel worn along its bottom, can tear under pressure. A lighter cable pass or replacing the section is the safer route.

WHAT WE JET

Lines We Hydro Jet in Des Moines

Houses, rentals and food service kitchens, from one sink branch to the main lateral.

  1. 01

    Kitchen Sink Branches

    Grease, coffee grounds and starch pile up between the sink trap and the stack. Jetting restores full bore instead of poking one hole through the deposit.

  2. 02

    Laundry Drains

    Lint mats and detergent sludge cleared from the standpipe and the horizontal drain it feeds, often the slowest line in a basement.

  3. 03

    Main Sewer Laterals

    The run from the cleanout to the city connection, jetted end to end with a nozzle chosen for clay, cast iron or plastic.

  4. 04

    Root Fibers After Cutting

    After a cutter opens a root mass, the water stream flushes loose fibers away so they cannot snag paper and wipes.

  5. 05

    Food Service Kitchen Lines

    Branches from compartment sinks, dish machines and floor sinks to the grease device, jetted on a schedule after the kitchen closes.

  6. 06

    Piping Around the Grease Device

    We jet the inlet and outlet piping of a trap or interceptor and check it on camera. Routine pumping of the device itself goes to a WRA certified grease hauler under the metro FOG Ordinance.

WHY CLOG BUSTERS

Why Des Moines Calls Clog Busters to Jet a Line

  • No Jetting Without Footage A camera inspection comes before the jetter on every line, and you can watch the screen with us.
  • Nozzles Matched to the Deposit A penetrating nozzle opens a stoppage, a rotating head scours grease and scale, and a root cutter shears intrusion. The head follows the deposit and the pipe material.
  • We Tell You When Not to Jet If a line is too fragile for pressure, you hear that before anything runs, along with what a repair would involve.
  • Proof on the Screen Afterward A second camera run shows the cleaned pipe wall, so you see the result rather than take our word for it.
  • Maintenance Set by Evidence For kitchens and rentals with repeat grease or lint trouble, the after footage tells us how often the line should be jetted.
  • Open All Hours on Vandalia Road Our Des Moines branch is open 24 hours a day, 7 days a week, so a line that backs up at midnight still reaches a crew.

How We Hydro Jet a Des Moines Line

Find the access, inspect, pick the method, clean the full run, then verify.

  1. Find the Access Point

    Jetting works best from a cleanout at the stack base or outside the foundation. Without one, we find another entry and discuss adding a cleanout.

  2. Camera the Line

    The camera identifies the pipe material, what is coating it and the condition of every joint before any pressure goes in.

  3. Choose Jet, Cable or Repair

    Sound pipe holding grease, scale, lint or silt gets jetted. A hard obstruction may need a cable pass first. Broken pipe moves to a repair conversation.

  4. Clean the Whole Run

    We work the nozzle through the full length of the line and back, so buildup beyond the original stoppage is flushed out too.

  5. Re-Camera and Run Water

    A second camera pass confirms the wall is clean, then a high volume flow test checks that the line carries a full load before we pack up.

REVIEWS

Hear From Some Of Our Customers

Don't Just Take Our Word For It

See All Reviews
4.9 4.9-star Google rating

“Max did a great job with our plumbing issue. He came same day and was very helpful an communicated every step of the way. Cleaned everything up when he was done. Will definitely call them for future issues.”

“I had my furnace inspected for fall maintenance today, and the tech mentioned my drain was backing up - not exactly the news I wanted to hear! I called Clog Busters and they had someone out within the hour, which already impressed me. Max was the technician, and he was absolutely splendid. He took the time to explain everything thoroughly without being condescending about it, which I really appreciated. He was clean and respectful of my home and belongings the entire time he was here.”

“Jordan Rambo was amazing he spent the extra time cleaning up area and taught me what I should and shouldn’t do for drains he was professional, extremely knowledgeable and polite. I would recommend him any time !”

“I live in an area with a lot of tree roots and need to get my sewer drain augered regularly. when jordan came to issue me a quote he also gave me so much information other businesses hadn’t. after he was finished completing the service he cleaned up after himself and gave me a thorough synopsis.”

“Rambo, was outstanding! If I could give 10 stars I would! Did everything he could to help and explain everything where I could understand!”

“Nick did an amazing job at our house today 8-29-2026. He was very informative, professional and answered all our questions. Couldn't ask for anything better.”

“Rambo did a great job. Took care of us and gave tips on how to unclog myself next time. Fast service.”

“Caleb and Noah were a lifesaver. Needed the kitchen drain cleaned after guests ran potato peels down the disposal on Christmas Day. They take emergency calls and made sure I didn't have to wash Christmas dishes in the bathtub.”

“Max showed up and cleared a clog from our kitchen sink drain. He was professional, prompt and honest with pricing. He found a larger issue that he provided quotes for, and was able to complete that work the same day. Thank you Max”

“Efficient, professional and knowledgeable service. Jordan and Evan did a fantastic job for us. Highly recommend!”

FAQ

Hydro Jetting Questions From Des Moines

Still stuck? Call the Des Moines shop at (515) 259-1991.

It can if the pipe has already failed, which is why we never jet without a camera inspection first. Sound clay, cast iron and plastic lines handle jetting well when the nozzle suits the material. Cracks, separated joints and cast iron rusted thin are the warning signs. When the footage shows them, we recommend a repair instead of pressure.

Call Now (515) 259-1991